[Zope] removing -D

Jens Vagelpohl tommymi@concentric.net
Sat, 25 Sep 1999 12:40:12 -0400


hi tim,

the "-D" is in the start script at the top level of your zope installation.
you need to remove it right there.

jens

Jens Vagelpohl

Systems Administrator
Washtenaw Development Council


> -----Original Message-----
> From: zope-admin@zope.org [mailto:zope-admin@zope.org]On Behalf Of Tim
> Wilson
> Sent: Saturday, September 25, 1999 12:00
> To: Zope Listserv
> Subject: [Zope] removing -D
>
>
> Hi everyone,
>
> I've read many times that the -D option in z2.py causes Zope to run in
> debug mode. Apparently that's the default behavior. Others have said that
> you can edit z2.py and remove it. My problem is that I can't figure out
> what part of z2.py to change to start Zope in "non-debug mode." BTW, I'm
> running Zope on a Linux system.
>
> -Tim
>
> --
> Timothy Wilson       | "The faster you  |  Check out:
> Henry Sibley H.S.    |  go, the shorter | http://slashdot.org/
> W. St. Paul, MN, USA |  you are."       | http://linux.com/
> wilson@chem.umn.edu  |       -Einstein  | http://www.mn-linux.org/
>
>
> _______________________________________________
> Zope maillist  -  Zope@zope.org
> http://www.zope.org/mailman/listinfo/zope
>
> (To receive general Zope announcements, see:
> http://www.zope.org/mailman/listinfo/zope-announce
>
> For developer-specific issues, zope-dev@zope.org -
> http://www.zope.org/mailman/listinfo/zope-dev )
>