[Zope] New kinds of problems

[MANUEL JOSE AMADOR BRIZ]

Which still sucks because most of the software will default to gcc, and 
compiled RPMs and binaries in other distributions fail sometimes too.


but thanks for the tip.  I tend to be something of a \"distracted professor\"  
(is that the way to put it?) sometimes.
Quoting Bill Anderson <bill@noreboots.com>:

> MANUEL JOSE AMADOR BRIZ wrote:
> > 
> > Thanks, here are my two cents:
> > 
> > Mini quick howto to connect to a sybase ASA/ASE:
> > 
> > Get any 2.2 linux distro installed, except red hat 7 (compiler
> problems, it
> > WILL fail).
> 
> Only if you didn\'t read the RELEASE-NOTES.
> Use kgcc, it is the same compiler as RH 6.2 has.
> 
> ---
> root@darwin in /root 
> $ cat /etc/redhat-release 
> Red Hat Linux release 6.2 (Zoot)
> root@darwin in /root 
> $ gcc --version
> egcs-2.91.66
> root@darwin in /root 
> ---
> ucntcme@locutus in /home/ucntcme 
> $ cat /etc/redhat-release 
> Red Hat Linux release 7.0 (Guinness)
> ucntcme@locutus in /home/ucntcme 
> $ kgcc --version
> egcs-2.91.66
> ---
> 
> ...
> > exit python and go to the zope folder, then run ./start
> > 
> > if zope starts, you\\\\\\\'re all set
> 
> not quite. You should stop zope, open a new terminal, and start zope
> from there. More often than not, you will need to set up the $SYBASE
> variables in the zope start up script. Running Zope in a \'clean\'
> terminal will test the environment.
> 
> 
> --
> E PLURIBUS LINUX
> 
> 
> _______________________________________________
> Zope maillist  -  Zope@zope.org
> http://lists.zope.org/mailman/listinfo/zope
> **   No cross posts or HTML encoding!  **
> (Related lists - 
>  http://lists.zope.org/mailman/listinfo/zope-announce
>  http://lists.zope.org/mailman/listinfo/zope-dev )
> 

----------------------------------------------------------
   Universidad Federico Santa Maria - Campus Guayaquil
	      Enviado por:  www.usm.edu.ec