[Zope] Using sendmail on FC5 with Zope 2.8.7

[Jonathan]

Can you run sendmail with the -D (debug option) and then check the log file 
to see what sendmail thinks is happening?


Jonathan

----- Original Message ----- 
From: "Ignacio Valdes" <ivaldes at hal-pc.org>
To: "Andreas Jung" <lists at zopyx.com>; <zope at zope.org>
Sent: Wednesday, July 05, 2006 2:58 PM
Subject: Re: [Zope] Using sendmail on FC5 with Zope 2.8.7


> Looking at the running daemon's, it only shows sendmail, no exim. I have 
> an O'Reilly book on sendmail that shall remain nameless. Thoughts on the 
> book: unhelpful, daunting and examples don't work. Egads.
>
> -- IV
>
> On Wed, 05 Jul 2006 20:50:46 +0200
>  Andreas Jung <lists at zopyx.com> wrote:
>>
>>
>> --On 5. Juli 2006 13:41:32 -0500 Ignacio Valdes <ivaldes at hal-pc.org> 
>> wrote:
>>
>>>
>>> Hi, I'm trying to get Mailhost to work on Fedora Core 5 with Zope 2.8.7.
>>> Sendmail is up and running on FC5, Mailhost is installed and set to
>>> localhost, port 25. However, nothing seems to happen when an e-mailable
>>> event occurs. I did not configure sendmail in anyway, it was the stock
>>> one on FC 5 install. I don't know where to begin as to how to get this 
>>> to
>>> work.
>>>
>>
>> This basically an off-topic question. You might check the mail logfiles
>> to figure out about potential sendmail problems. Btw. are you sure that 
>> FC5 uses sendmail? FC5 used to use Exim.
>>
>> -aj
>
> _______________________________________________
> Zope maillist  -  Zope at zope.org
> http://mail.zope.org/mailman/listinfo/zope
> **   No cross posts or HTML encoding!  **
> (Related lists - http://mail.zope.org/mailman/listinfo/zope-announce
> http://mail.zope.org/mailman/listinfo/zope-dev )
>