Hello I have a slight problem with the software. I use Suse 7.2, and have installed Zope using Yast2, so I didn't compile it myself... I set up an initial username and password using the following... ./zpasswd inituser It seems to accept it. When I go to http://localhost:8080; and I try to log on, it never accepts my username/password. I didn't know if there was a conflict with Apache since Zope loads ZServer, so I stopped the Apache service. So I can only access port 8080. It still doesn't accept it. What shall I do? Matthew Speedy - Fresh Linux User ******************************************************************** The contents of this email are confidential to the intended recepient. It may not be disclosed to or used by anyone other than this addressee, nor may it be copied in any way. If received in error, please contact Berkeley Independent Advisers Ltd. on 024 7623 2000 quoting the name of the sender. It is the recepient's responsibility to check any attachments for viruses. Berkeley Independent Advisers Limited recommend that all attachments are checked before use. No contracts may be concluded on behalf of Berkeley Independent Advisers Limited by means of email communications. Where signatures are required email will not be accepted as a substitute. Please report any misuse of email to Compliance@berkeley-ifa.co.uk Berkeley Independent Advisers Limited, Eaton House, 1 Eaton Road, Coventry, CV1 2FJ. Tel: 024 7623 2000 Fax : 024 7623 2070. Berkeley Independent Advisers Limited is regulated by the Personal Investment Authority.