I suspect that this is related to the fact that the DA has not been intergrated with the New and Improved transaction control machinery for ZODB3. I've asked the question internally -- hopefully we'll have a response (note I didn't say solution!) later today... --Rob
-----Original Message----- From: Graham Chiu [mailto:anon_emouse@hotmail.com] Sent: Tuesday, July 27, 1999 6:31 AM To: zope@zope.org Subject: Re: [Zope] ODBC and Inserting not committed
In article <58M3aDAI0Wn3Ew48@compkarori.co.nz>, Graham Chiu <anon_emouse@hotmail.com> writes
Try running Zope in single thread mode ('-t 1' on the z2.py command line) and see if the problem persists. If so, then the ODBC driver will probably need to be 'thunked' which is a pretty trivial 10 minute change to the code.
I ran it in single thread mode, and the problem has gone away. Actually I just found that updates also did not commit before. Now both commit.
Oops, spoke too soon. Changes are now saved between browser sessions, but are discarded once Zope2b1 is closed down.
------- Regards, Graham Chiu gchiu<at>compkarori.co.nz
_______________________________________________ Zope maillist - Zope@zope.org http://www.zope.org/mailman/listinfo/zope
(To receive general Zope announcements, see: http://www.zope.org/mailman/listinfo/zope-announce
For developer-specific issues, zope-dev@zope.org - http://www.zope.org/mailman/listinfo/zope-dev )