I'm a newbie running Zope 2.7.0 on Linux. I have some DTML problems and I'd like to get traceback information on. Using tcsh, I ran setenv Z_DEBUG_MODE 1 and then ran 'runzope' in the same window after verifying that Z_DEBUG_MODE is indeed set to 1. When I run my sample code, I get an error message in Zope that is shown at the end of this message. With Z_DEBUG_MODE set, I was expecting to get a traceback in the error message. My expectation was set from the chapter on debugging in the "Zope Bible". Questions: 1) Did I understance the Zope Bible correctly, i.e. the message below should have a traceback in it? 2) Did I do something wrong when setting up the environment? 3) The error message refers to an error log. I checked the log subdirectory in the directory where my zope instance appears and could not find meaningful information about this error there. Is there somewhere else to look? 4) If I misunderstood, how can I see a traceback? Thanks in advance for any help. Jim _____________________________Error Message Starts Here________________________________________________ Site Error An error was encountered while publishing this resource. *Error Type: AttributeError* *Error Value: Entries* ------------------------------------------------------------------------ Troubleshooting Suggestions * The URL may be incorrect. * The parameters passed to this resource may be incorrect. * A resource that this resource relies on may be encountering an error. For more detailed information about the error, please refer to the error log. If the error persists please contact the site maintainer. Thank you for your patience.