Would it be because, Zope reports the correct content-size, then roxen then sticks in the gubbins from it's tags, but roxen neglects to change the content-size again? |>-----Original Message----- |>From: michel@zope.org [mailto:michel@zope.org]On Behalf Of Michel |>Pelletier |>Sent: Monday, November 08, 1999 5:05 PM |>To: Tony McDonald |>Cc: Zope List |>Subject: Re: [Zope] Zope and Roxen - small byte limit on CGI? |> |> |>Tony McDonald wrote: |>> |>> At 2:34 pm -0700 7/11/99, Bill Anderson wrote: |>> >Tony McDonald wrote: |>> > > It seems that my Zope.cgi is only returning the first |>(small number) of |>> >> bytes or so of CGI on pages where there are Roxen tags! |>> >> |>> >> On pages such as QuickStart I can have as much output as I |>like. Once I add |>> >> a Roxen tag, things go awry. |>> >> |>> >> Some of the numbers that pop up are 352, 1301 and 2700 bytes. |>> >> |>> >> Is anyone else seeing this behaviour? |>> > |>> >Any particular roxen tag? |>> >I have had problems with combining Zope's tree tag with Roxen's <gtext> |>> >mouseover aspect. None of the page renders. I pull out the tree, and it |>> >works. But I haven't dealt with this particular one too much yet. |>> > |>> >Bill |>> |>> It seems to happen with <configtabs>, <gtext>, <obox>, <tablify>, |>> <fl> and <sqloutput> ie quite a few.... |> |>Guessing... |> |>perhaps Roxen starts parsing and interpreting the tags before Zope has |>finished serving them up? All of this thread sounds like a Roxen |>issue, I see no reason why Zope would treat RXML tags any differently |>than any other kind of tag. |> |>-Michel |> |>_______________________________________________ |>Zope maillist - Zope@zope.org |>http://lists.zope.org/mailman/listinfo/zope |> No cross posts or HTML encoding! |>(Related lists - |> http://lists.zope.org/mailman/listinfo/zope-announce |> http://lists.zope.org/mailman/listinfo/zope-dev ) |>