Hi Alejandro, it is not so hard as it looks like at the start. You should get Python as source and Zope as source. There is always a README and mostly an INSTALL file too which describes step by step how to build and install. In short, you set the CC var as you described, go to the directory you unpacked python, then run: ./configure --with-thread make make test make install (ok, you can omit 'make test') then go to the zope source and python (<--- make sure you get _your_ new configured python here, not an older one on your system. If in doubt use the full path, e.g. /usr/local/bin/python ) python wo_pcgi.py after running it, call python zpasswd.py inituser then ./start Good luck Tino --On Montag, 23. Juli 2001 18:02 -0300 "Alejandro T. Singer" <alejandro.singer@homenajear.com> wrote:
I'm using Zope with python and i'm having problems due to my Data.fs file is over 2GB. According to Python's Library Reference 8.1.1 I have to re-compile python with this sentence:
CC="-D_LARGEFILE64_SOURCE -D_FILE_OFFSET_BITS=64" export CC ./configure
1- I'm using Red HAt Linux 6.2 How do I know if it's large-file-capable ? 2- How do I re-compile python as described in 8.1.1, there's any step-by-step guide ?
Thanks
Alejandro Singer