Can you run sendmail with the -D (debug option) and then check the log file to see what sendmail thinks is happening? Jonathan ----- Original Message ----- From: "Ignacio Valdes" <ivaldes@hal-pc.org> To: "Andreas Jung" <lists@zopyx.com>; <zope@zope.org> Sent: Wednesday, July 05, 2006 2:58 PM Subject: Re: [Zope] Using sendmail on FC5 with Zope 2.8.7
Looking at the running daemon's, it only shows sendmail, no exim. I have an O'Reilly book on sendmail that shall remain nameless. Thoughts on the book: unhelpful, daunting and examples don't work. Egads.
-- IV
On Wed, 05 Jul 2006 20:50:46 +0200 Andreas Jung <lists@zopyx.com> wrote:
--On 5. Juli 2006 13:41:32 -0500 Ignacio Valdes <ivaldes@hal-pc.org> wrote:
Hi, I'm trying to get Mailhost to work on Fedora Core 5 with Zope 2.8.7. Sendmail is up and running on FC5, Mailhost is installed and set to localhost, port 25. However, nothing seems to happen when an e-mailable event occurs. I did not configure sendmail in anyway, it was the stock one on FC 5 install. I don't know where to begin as to how to get this to work.
This basically an off-topic question. You might check the mail logfiles to figure out about potential sendmail problems. Btw. are you sure that FC5 uses sendmail? FC5 used to use Exim.
-aj
_______________________________________________ Zope maillist - Zope@zope.org http://mail.zope.org/mailman/listinfo/zope ** No cross posts or HTML encoding! ** (Related lists - http://mail.zope.org/mailman/listinfo/zope-announce http://mail.zope.org/mailman/listinfo/zope-dev )